Billet-specialties 248855 - Battery Lug Bracket Chassis Mount Bedienungsanleitung PDF herunterladen

Billet Specialties, Inc. 500 Shawmut Avenue La Grange, Illinois 60526 PH 800.245.5382 Fax 708.588.7181 www.billetspecialties.com

WARNING!

• Disconnect battery before installation

• Do not allow charging lug to come in contact with the chassis or body at

any time - Electrical Damage Will Occur.

BRACKET MOUNTING

• Cut out the template provided and tape to chassis in desired position.

• Center punch hole centers & drill mount holes with a #7 or 13/64” drill bit.

• De-burr all edges and paint exposed bare metal for corrosion protection.

• Apply Loc-Tite to threads on the 1/4-20 socket head cap screw & thread

cap screw thru bracket and chassis.

• Finish by installing 1/4” washer and nut and tighten firmly.

MALE LUG ASSEMBLY (From Charger)

• Slide plastic handle over cable then strip approximately 3/4” of cable

insulation (Note: works with 1 or 2 gauge cable).

• Insert the exposed wire completely into the charging lug and secure with

the 3/8-16 socket set screw.

• Next slide the plastic handle over male charging lug and secure with

#8-32 socket head cap screw.

FEMALE CHARGING RECEPTACLE

See Illustration at right.

#248850 / #248855 - Battery Lug Bracket Chassis Mount

4.125”

DRILL TEMPLATE - USE #7 or 13/64” Drill Bit

1/4-20 Lock Nut

1/4” Flat Washer

1/4-20 x 1”

Socket Head Cap Screw

Nylon Bung with Female Charging Lug

Chassis Mount Battery Lug Bracket

Nylon Lug Washer

Flat Washer

Lock Washer

1/2-20 Hex Nut

1/2” Battery Terminal (Not Supplied)

1 or 2 Gauge Wire - Strip Approx 3/4 in.

MALE LUG ASSEMBLY

Install between flat washer & lock washer

Seite 1

Billet Specialties, Inc. 500 Shawmut Avenue La Grange, Illinois 60526 PH 800.245.5382 Fax 708.588.7181 www.billetspecialties.comWAR

Keine Kommentare

Billet-specialties 248855 - Battery Lug Bracket Chassis Mount Bedienungsanleitung